Euromaid RFT9 Dokumentacja Pobierz pdf (Strona 5)

13. To assemble the glass canopy:

13.1. For model EUC90GS & EUC60GS only (See Figure 3c)

Slide the glass over the body at the base of the flue section and match the screw holes on the

glass to the screw holes on the ranghood. Insert rubber plugs into the holes and insert screws.

Screw securely into place. Do not screw too tightly as this may damage the glass.

14. Remove protective plastic film.

15. If you require a flue cover length that is greater in length than that supplied, extended flue kits are available

as an accessory. Please contact your place of purchase.

16. Plug the power cord into the power point.

Figure 3a

Figure 3b

Figure 3c

OPERATION

The push-button control panel (see Figure 3 below) is located on the front of the rangehood and includes:

Figure 3

1. Light switch (A)

2. Fan switch (B- high speed, C-mid speed, D-low speed)

3. Motor-off (E)

LIGHT CONTROL

Switch on/off the lights by pressing Switch (A) on the switch panel.

FAN CONTROL

Select required fan speed: HIGH, MID or LOW SPEED by pressing (B), (C) or (D) respectively on the switch

panel.

Installation Procedure – Recirculating System

In order for the rangehood to be used in the filtration mode whereby the air is recirculated by active carbon

filters, two active carbon filters (which are supplied as separate accessories) must be installed on both sides of

the exhaust fan. Under regular use of the rangehood, the carbon filters must be replaced at least once every

three (3) months to maintain its filtration efficiency.

1 2 3 4 5 6 7

Brak uwag

Euromaid RFT9 Dokumentacja Strona 5